Upgraded Flip Remote Key Fob 433MHz 4D67 for Toyota Prado 120 RAV4 Kluger 50171

Description:
1. The item is an upgraded flip remote key Fob. Frequency 433MHz 4D67 Chip inside with uncut TOY43 blade.
    if you need TOY47 blade,pls leave us a message
2. The remote key includes key housing, circuit board, chip and battery. It's a full remote ignition key.
3. You'll need to program the key at locl automotive locksmith before using.
4. Replacement for genuine Part no.50171
5. Suitable for Following cars:
Toyota Prado120 : 09/2004 to 08/2009 (Built Date)
Toyota RAV4:         7/2003 to 11/2005 (Built Date)
Toyota Kluger:       8/2003 to 5/2007 (Built Date)
Toyota Avensis:    10/2003 to 2010 (Built Date)
Toyota Tarago:      4/2003 to 1/2006 (Built Date)
Note - if the ID number and chip type doesn't match, please don't buy. It will not work.
Programming Manual
Remote
1.       Open Driver side door
2.       Put the Original key in and out of ignition 2 times
3.       Close and open driver door 2 times
4.       Original Key in and out once
5.       Shut and open door twice
6.       Close door
7.       Put Original Key in the ignition and Turn ignition on
8.       Turn ignition off and remove key
9.       Door locks will cycle
10.   Do the following for all remotes:
Press lock and unlock together for 1s, then press the lock button
11.   Locks will cycle put key in ignition turn to on then off
12.   Remove key from ignition, close door and test remote
To Delete All Remotes from the Vehicle
 At Step 7, turn the key on and off 5 times then remove key, door locks will cycle 5 times. Turn the key on then off. Open shut door. All remotes that were coded into the car, have now been removed.
 
Program keys
 
1.       Put Original master key in and out of ignition 5 times. Finish with key in ignition (in, out, in, out, in, out, in, out, in)
2.       Open and shut door 6 times
3.       Remove original key and insert the new key (Do not turn the key, just insert it into the ignition
4.       Leave for 60s (or til light goes out)
5.       After 60s security light stops flashing then you can start car.
6.       Take key out
7.       Open and shut door
If you make a mistake at any point in the procedure, use original key to start the car. Take the key out, open and close door. Now you are ready to start again.